Recapping basics
From FabLab Wiki
What recapping is, why old consoles need it, and how to do it safely.
About this page: the write-up was drafted with the help of AI and may contain mistakes. The capacitor lists are Omar's FabLab's own records. Spotted an error? Let us know.
Recapping means replacing a device's electrolytic capacitors with new ones. Electrolytic capacitors contain a liquid or gel electrolyte that slowly dries out or leaks over the years. In consoles that are now 25 to 45 years old, worn capacitors can cause symptoms such as no power, a dim or unstable picture, buzzing or missing sound, and leaked electrolyte can corrode the board itself.
Before you start
- Identify the board. Find the revision or part number printed on the board and use the matching list in Capacitor lists.
- Power supplies can be dangerous. Mains-powered supplies can hold a charge after unplugging. Only work on them if you know how to discharge them safely.
- Take photos first so you can check each capacitor's position and orientation later.
Choosing replacements
- Capacitance (µF): match the original value.
- Voltage: the same or higher rating is fine; never lower.
- Size and type: check the diameter, height and lead spacing fit, and use the same mounting type (through-hole or surface-mount) unless you know an alternative fits.
- Quality: use parts from reputable manufacturers and suppliers, rated for 105°C where possible.
Doing the work
- Mind the polarity. Electrolytic capacitors are polarised; the negative side is marked on the part and usually on the board. Fitting one backwards can make it fail, sometimes violently.
- Clean up leaked electrolyte with isopropyl alcohol before fitting new parts, and check the traces underneath for corrosion.
- Replace one at a time to avoid mixing up positions.
- Test the console fully afterwards: video, audio, controls and media.